End Connector Kit

The End Connector Kit can be used with any Waters 3.9 mm or 4.6 mm I.D. cartridge. The cartridge and the End Connector Kit are purchased separately. When the performance of the cartridge deteriorates, you just replace the cartridge and reuse the end-fittings. The maximum pressure rating for this equipment is 40Mpa (400 atm, or 6000 psi).

The End connector kit contains three distinct parts, including 2 replacement o-rings and 1 Replacement c-clip.

When putting your assembly together, assemble your cartridge and attach the End Connector Kit following the instructions carefully to ensure no blockage or backflow is created. Remove the plastic end caps from the cartridge, and keep them for later for cartridge storage. Slide a retaining nut onto the cartridge with the open end of the nut towards the end of the cartridge. Press a c-clip into the groove of the cartridge until it snaps into place, and then place the end-fitting onto the cartridge and screw together the retaining nut and end-fitting until hand-tight. Each side of the assembly needs to be assembled accordingly. However, please ensure the threads of the end-fitting are not visible. If they are, the parts are not properly together and you will need to unscrew and reassemble them.

You can increase your productivity with the ideal lab equipment. To learn more about the variations of the same product, such as the Waters End Connector Kit, or to find additional products that work with it, check out our shop for lab equipment; you can browse through our website, refer to our catalog and ensure your lab needs are met as needed.

You may also be interested in the O-Ring, Kalrez, 2/pk; the DuPont™ Kalrez® 4079 perfluoroelastomer parts are a black, low compression set product for use in many dry and wet semiconductor process environments. It has excellent chemical resistance, good mechanical properties, and outstanding thermal stability. The equipment exhibits low weight loss in reactive plasmas and has a good response to temperature cycling effects. Although it is not recommended for use in amines, for other general-purpose uses, a maximum continuous service temperature of 316 °C is suggested. Short excursions to higher temperatures are also possible.