A protocol used as guideline when conducting performance maintenance (PM) on a 2690/2695/e2695 Separations Module Module.

Alliance 2695 Part Locator

The attached Certificate of Structural Integrity applies to the 2695 Separations Module Firmware Version 3.00.

The attached Declaration of Conformity covers the 2695 and e2695 Separations Modules.

The attached Certificate of Structural Integrity applies to the 2695 Separations Module Firmware Version 2.04.

The 2695 Separations Module Firmware Version 2.04 Release Notes contain important information about this release.

How to replace the syringe in the Alliance 2695 Separations Module.

The Waters 2695 Separations Module Firmware Update Version 2.04 Supplemental Release Notes contain important information about this release.

You receive a 2695 Instrument Failure Message with Continuous Degas Mode.

The attached user manual describes the features and use of the Waters 2695 Separations Module, and provides installation and maintenance procedures.

The attached user manual describes the basic steps required to set up the Waters 2695 Separations Module and make a run.

This document explains how to configure communication settings between the data system and the Alliance 2690/2695 or 2790/2795.

The Alliance 2695 separations module firmware Version 2.04 update addresses some isolated occurrences of sequenced vials being missed but not reported as such in the final results of that sample sequence.

The needle wash setting on the Alliance 2695 Separation Module and 2695D Separations Module always remains set to Normal when controlled by Empower software.

The attached reference sheet provides a flowchart that lists the sequence of steps required to degas a Waters Alliance 2695 separations module.

There are changes to the way in which MassLynx 4.0, Millennium32, and Empower respond to Alliance column heater alarm conditions, depending on whether the Alliance system has firmware Version 2.00 or 2.02.

The Static Leak Test Decay Rate value for Alliance 2695, 2795, and 2796 systems with Firmware Version 2.02 and later is < 600 PSI.

When connecting a 474 detector to a 2695 separations module, you need to make a connection between the Inject Start terminal of the 2695 and the Mark In terminal of the 474.

This article lists additions to the Empower Software Release Notes that apply to 2695 and 2795 separations modules.

This procedure outlines the steps for installing the Ceramic Check Valve Cartridge for 2695, 2695D, and 2795 Separations Modules.

How to install the Drain Tube Replacement Kit (part number 700001891) in the Alliance 2690/2695 and 2790/2795 Separations Modules.

How to replace a check valve cartridge in the Alliance 2695 and 2795 Separations Modules.

How to replace the inline filter in the Alliance 2695 and 2795 Separations Modules.

How to replace all seals in the pump head assembly of the Alliance 2695 and 2795 Separations Modules.

When using Millennium32 Version 3.20 with a Waters 2695, acquisition stops due to unexplained User Abort messages in the Message Center.